NZ 300ZX Owners Club Forum

lostsoul · Posted: Mon Mar 02, 2015 12:22 pm Post subject: Camshafts

These are the ones taken from my engine - made 490rwkw with these fitted.

They have the following spec's.

Advertised Duration = 274 deg. ( Factory = 248 deg. )
@.050" Duration = 219 deg. ( Factory = ?? )
Valve Lift = 9.3mm ( Factory = 8.5mm )

They are in serviceable condition ie: showing marks on the journals but nothing bad and not under-size.

They are series 2 cams so will need spacer kit https://conceptzperformance.com/Cart/description.php?II=811 to run with series 1 inlet can gears.

$300
_________________
"Understeer is when you hit the wall with the front of the car and
oversteer is when you hit the wall with the rear of the car.
Horsepower is how fast you hit the wall,
torque is how far you take the wall with you." Wink

Gammy · Posted: Sat Mar 07, 2015 3:54 pm Post subject:

Did you need to go to solid lifters, or are they more or less drop in once the valve springs are done?

lostsoul · Posted: Sat Mar 07, 2015 6:19 pm Post subject:

NozMonkeys · Posted: Sat Mar 14, 2015 9:21 am Post subject:

I could be interested but it wont be for a couple of months.

lostsoul · Posted: Sat Mar 14, 2015 2:00 pm Post subject:

Gammy · Posted: Sun Mar 15, 2015 10:17 am Post subject:

Managed to sort some springs so I'll grab them, sorry for not mentioning that.